Broadcast Tools DSC-20 Instrukcja Instalacji Pobierz pdf (Strona 53)

Preliminary 8-2002 RSHD Smartcaster Installation Manual

The DSC-20 may be configured to control any combination of the two devices listed above. When

the DSC-20 is controlled from a PC's serial port, twenty - 48 character ASCII serial strings and/or

100 memory selections are provided for the above-mentioned devices. Advance programming of

the DSC-20 is accomplished with a NON-DEDICATED computer.

With these two devices you can control a lot of the switching externally of the Smartcaster.

Breaking the process down into smaller parts may make it easier to set up a workable system.

You can usually make a Starguide 3 with these two units replace a large pile of the older sat

receivers. Two port cards will let Smartcaster record from one card and switch the other card

live to air.

It is beyond the scope of this document to get very far into the actual set up of these devices, just

know that like a tone decoder, a few bucks spent here can save a lot of money with other items.

Save yourself some time and effort, buy these goodies for every install you do of the

Starguide receiver.

The Connect O' Adapter 15, (COA-15), provides an effective way to convert the DB-15

connector to removable screw terminals. The COA-15 is designed to plug into the male

15-pin D-Sub connector on any Starguide II or III Audio Module. The COA-15 is

equipped with an eight-position removable screw terminal for connection to the 4 relays.

Mounting screws are provided to secure the COA-15 to the Audio Modules DB-15

connector.

The Connect O' Pad, (COP), provides an effective way to connect and adjust the audio

outputs on your Starguide II and III receiver. The COP is designed to plug into the male

1 2 ... 48 49 50 51 52 53 54 55 56 57

Brak uwag

Broadcast Tools DSC-20 Instrukcja Instalacji Strona 53